Differences

This shows you the differences between two versions of the page.

--- android_app [2019/01/18 16:54] – [Settings] hakcenter
+++ android_app [2019/01/18 16:56] – [Sweep] hakcenter
@@ Line 63: / Line 63: @@
 ==== Debugging ====
 === Emulate ===
-Enabling emulate will by-pass the LBB startup procedures and drop right into the main loop. It is good for testing Turbo / LBB fuctions without the engine running to get the turbo shaft speed up to the minimum start speed. It also will allow you to test your brake / cruise switches.
+By-passes the LBB startup procedures and drop right into the main loop. It is good for testing Turbo / LBB fuctions without the engine running to get the turbo shaft speed up to the minimum start speed. It also will allow you to test your brake / cruise switches.
 ----
 === Calibrate ===
-Enabling calibrate will set the LBB to send the calibration code for the entirety that it is enabled. This is a good way to calibrate your actuator when you remove it and install it again. Just power up the system, and enable calibrate for 10-15seconds.
+Sets the LBB to send the calibration code for the entirety that it is enabled. This is a good way to calibrate your actuator when you remove it and install it again. Just power up the system, and enable calibrate for 10-15seconds.
 ----
 === Sweep ===
-This will start the sweeping procedure. While it is sweeping, you'll see what the current position is, and if there's over 110% feedback, positions will be added to the screen prompt. If you have a lot of feedback you may need to clean up the piston housing in the turbo.
+Begin sweeping procedure. While it is sweeping, you'll see what the current position is, and if there's over 110% feedback, positions will be added to the screen prompt. If you have a lot of feedback you may need to clean up the piston housing in the turbo.
 ===== Settings =====
 {{ :app:android_app_settings.png?nolink&200|}}There are various settings available for the application.