android_app
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| android_app [2019/01/18 16:54] – [Settings] hakcenter | android_app [2019/01/18 16:55] – [Calibrate] hakcenter | ||
|---|---|---|---|
| Line 63: | Line 63: | ||
| ==== Debugging ==== | ==== Debugging ==== | ||
| === Emulate === | === Emulate === | ||
| - | Enabling emulate will by-pass the LBB startup procedures and drop right into the main loop. It is good for testing Turbo / LBB fuctions without the engine running to get the turbo shaft speed up to the minimum start speed. It also will allow you to test your brake / cruise switches. | + | By-passes |
| ---- | ---- | ||
| === Calibrate === | === Calibrate === | ||
| - | Enabling calibrate will set the LBB to send the calibration code for the entirety that it is enabled. This is a good way to calibrate your actuator when you remove it and install it again. Just power up the system, and enable calibrate for 10-15seconds. | + | Sets the LBB to send the calibration code for the entirety that it is enabled. This is a good way to calibrate your actuator when you remove it and install it again. Just power up the system, and enable calibrate for 10-15seconds. |
| ---- | ---- | ||
| === Sweep === | === Sweep === | ||
android_app.txt · Last modified: 2019/01/18 17:08 by hakcenter